HP OmniBook 800 Installation And Setup Manual page 13

4. Reset the OmniBook.
Press the reset button: Insert a pen tip or bent paper clip into the small
opening marked "RESET" on the right side of the computer. Press the
recessed button for 1 to 2 seconds. The OmniBook may take half a minute
or more to restart (reboot).
Pressing the reset button is similar to turning off a PC's power, then turning it
back on again. After this first time, you should not need to press the reset button
often.
If you have an OmniBook floppy drive attached when you reset the OmniBook,
make sure there's no disk in the drive (unless you set the option in the System
Configuration Utility to boot only from the hard drive). As on a PC, if there's a
disk in the floppy drive, the OmniBook looks there first for its startup files.
Starting Out with Your OmniBook
Setting Up the OmniBook
1-7