HP OmniBook 800 Installation And Setup Manual page 71

If the computer seems slow
Check that Cache is enabled (in the System Configuration Utility, open the
System menu and check Enable Cache).
You might need to install more RAM. The memory-expansion boards are HP
part numbers F1168A (16 MB), F1169A (32 MB) and F1119A (64 MB).
Try pressing the reset button.
If the infrared connection does not work
Try re-aligning the two devices to align their infrared ports. Make sure the two
devices are no more than 0.5 meter apart.
Check the settings in your communications software and in the OmniBook's IR
Monitor. IrDA must be enabled.
If a parallel device does not work
The bus speed of the device may be too slow for the OmniBook. Try decreasing
the OmniBook's bus speed by pressing
normal speed by pressing
If you cannot install Windows NT 3.51
In the System Configuration Utility, under the System menu, Boot Devices,
enable the checkbox Force PCI Bridge Configuration.
(-). You can restore the
FN+MINUS
(=).
FN+PLUS
Troubleshooting
Solving Basic Problems
5-7