HP OmniBook 800 Installation And Setup Manual page 40

Hp omnibook 800: setup guide
Hide thumbs Also See for OmniBook 800:
Table of Contents

Advertisement

Expanding the OmniBook
Replacing Internal Hardware
If your new hard drive has screws in different positions from the old one, you
will also need to adjust the insulator sheet. Compare the location of the screw-
holes in the new hard drive with those in the insulator sheet. If there is no screw
at position A, then unfold the flap at position A, and lay it flat before laying the
hard drive down on the insulator.
8. Holding the new hard drive by its edges, lay it in place. The right edge of the
hard drive should be flush with the edge of the compartment.
3-6

Advertisement

Table of Contents
loading

Table of Contents