To Set Up The Omnibook - HP OmniBook 800 Installation And Setup Manual

Hp omnibook 800: setup guide
Hide thumbs Also See for OmniBook 800:
Table of Contents

Advertisement

To set up the OmniBook

See "Battery Safety" in chapter 6 for the proper handling of batteries.
1. Install the battery.
Lay the battery pack into the battery compartment. The metal battery
contacts on the pack mate with contacts in the compartment.
Close the two latches.
The battery pack contains rechargeable batteries. The first time you use your
OmniBook, you should charge the battery for 1 or 2 hours before operating
solely on battery power. However, you can operate immediately with the ac
adapter plugged in—see the next section.
2. Connect the ac adapter and start charging.
Plug the power cord into the ac adapter, then into a grounded ac outlet.
Plug the connector from the ac adapter into the socket at the right-rear
corner of the OmniBook.
Important: If you will not be using the ac adapter for an extended period of
time, unplug it from the power source.
Starting Out with Your OmniBook
Setting Up the OmniBook
1-5

Advertisement

Table of Contents
loading

Table of Contents