Table of Contents
Advertisement
2.6.
Picture settings and guide lines
The picture settings can be adjusted by the 3 buttons on the video-interface. Press the
MENU
button to open the OSD settings menu. To switch to the next menu item, pressing
UP
and
DOWN
will change the selected value. The buttons are embedded in the housing to
avoid accidental changes during or after installation. The picture settings have to be done
separately for AV1 and AV2 while the corresponding input is selected and visible on the
monitor.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H (horizontal)
Position V (vertical)
IR-AV1 (out of function)
IR-AV2 (out of function)
Guide-lines left
Guide-lines right
U1-CNTRL
-
Guide lines for
rear-view camera (ON/OFF)
H-SIZE (horizontal)
picture adjustment
V-SIZE (vertical)
for rear-view camera
The menu's point „U1 CNTRL" does support the
guide lines options like shown beside:
Note: If the vehicle's CAN communication does not support the video interface, the guide-
lines cannot be used, even if they're once shown with the first operation!
Version 02.02.2018
Options:
All ON: Guide lines and PDC will be
displayed.
PDC ON: Only PDC displayed.
Guide ON: Only Guide lines displayed.
ALL Off: Guide lines and PDC will not
be displayed.
HW:CAM-GD (V94)
RL3-NAC
Advertisement
Table of Contents
