Enabling The Interface's Video Inputs (Dip 2-3); Rear-View Camera Setting (Dip 5); Choosing The Corresponding Head Unit Version; Settings Of The 4 Dip Switches (Can Function - Red) - r.LiNK 3008 NAC Manual

1.5.1. Enabling the interface's video inputs (dip 2-3)

Only the enabled video inputs can be accessed when switching through the interface's video
sources. It`s recommended to enable only the required inputs, for the disabled will be
skipped when switching through the video interfaces inputs.

1.5.2. Rear-view camera setting (dip 5)

If set to OFF, the interface switches to factory LVDS picture while the reverse gear is engaged
to display a factory rear-view camera or a factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input "Camera-IN" while the
reverse gear is engaged.
Note: Dip 1, 4, 6 and7 are out of function and have to be set to OFF.
1.5.3. Choosing the corresponding head unit version (dip8)
If set to ON, the video interface will communicate with the NAC low-version head unit.
If set to OFF, the high version of the head unit will be adjusted.
Note: Dip 1,4,6 and7 are out of function and have to be set to OFF.
1.6.

Settings of the 4 Dip switches (CAN function - red)

Dip position down is ON and position up is OFF.
Navigation / Sy5tem
NAC infotainments
Set all 4 dips to OFF.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Version 02.02.2018
Dip 1 Dip 2 Dip 3
OFF OFF OFF
HW:CAM-GD (V94)
Dip 4
OFF
RL3-NAC