Table of Contents
Advertisement
2.8.
Picture settings and guide lines
The picture settings are adjustable by the 3 push-buttons on the video-interface. Press the
MENU button to open the OSD settings menu or to switch to the next menu item. Press UP
and DOWN to change the selected value. The buttons are placed inside in the housing to
avoid accidental changes during or after the installation. Picture settings must be done
separately for AV1 and AV2 while the corresponding input is selected and visible on the
monitor.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H (horizontal)
Position V (vertical)
IR-AV1/2 (no function)
Front-CNTRL (duration of frontcam switch-back - 10, 15
or 20 seconds)
Guide L/R (guide lines adjustment)
UI-CNTRL (guide lines ON/OFF)
Size H/V (picture size horizontal/vertical)
Note: If there is no communication between interface and the vehicle`s CAN-bus (several
vehicles aren't compatible), the reverse gear guide-lines can`t be shown during the vehicle's
operation, even if they once appear after having switched the system to powerless!
Version 16.03.2022
HW:CAM(V100)/(V33)
CI-RL4-MIB
Advertisement
Table of Contents
