Picture Settings And Guide Lines - r.LiNK CI-RL3-R40 Manual

Video-inserter with 2 video inputs, rear-view camera input and can control

Table of Contents

2.8.

Picture settings and guide lines

The picture settings are adjusted by the 3 buttons on the video-interface. Press the

button to open the OSD settings menu. To switch to the next menu item, pressing

DOWN

will change the selected value. The buttons are embedded in the housing to avoid

accidental changes during or after installation. The picture settings have to be done

separately for AV1 and AV2 while the corresponding input is selected and visible on the

monitor.

Note: The OSD menu is only shown when a working video source is connected to the

selected video-input of the interface.

The following settings are available:

Contrast

Brightness

Saturation

Position H (horizontal)

Position V (vertical)

IR-AV1 (out of function)

IR-AV2 (out of function)

Guide-lines left

Guide-lines right

Guide lines (ON/OFF)

Note: If the CAN-box does not support the vehicle's CAN, the guide-lines cannot be used.

Version 16.03.2020

Optionen: GUIDE-CNTRL

All ON: Guide lines und PDC werden

angezeigt

PDC ON: Nur PDC wird angezeigt.

Guide ON: Nur Guide lines angezeigt.

ALL Off: Guide lines und PDC

werden nicht angezeigt.

HW: CAM(V97)/(V30)

and

CI-RL3-R40

Table of Contents