Table of Contents
Advertisement
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work
properly, take the following coorective steps:
P R O B L E M
Leakage under the
handle
The aerator has an
irregular or reduced
water ow
Water will not shut o
completely
There is leaking from the
sink drain at the base of
the sink.
There is a low ow of
Close
water.
Care & Maintenance
*To keep the product clean & shining, follow the steps below：
1.
Rinse with clean water & dry with a soft cloth
2.
Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3.
Do not use cloth with a coarse surface
4.
Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
C A U S E
Bonnet nut (12) has
come loose
10
Hexagon Nut
9
11
The aerator is dirty or
mis- tted
12
13
Cartridge may need to
be adjusted or replaced
The sink has a rough or
irregular surface.
The lter washer in the
hose connectors is dirty.
90˚
25˚
Left
Open
Hot Water
A C T I O N
Remove the index. Loosen
screw with hex wrench (21).
Remove the handle. Unscrew
cap (13) (by hand only). Tighten
bonnet nut (12) with an
adjustable wrench.
Remove the aerator and
check for debris.
Ensure that the rubber
washer is properly installed.
Remove the index. Loosen
screw with hex wrench (21).
Remove the handle . Unscrew
Hot
Water
cap (13) (by hand only). Tighten
bonnet nut (12) with an
adjustable wrench. Remove
the cartridge (11). Check for
cracks.
Apply additional silicone
sealant to the beveled side of
the drain ange. Retighten
and test for leaks
Turn o the water supply at
water valve and unscrew the
hose connectors from water
Push
supply lines. Clean the lter
washer in the water lines with
hot water, removing any debris
or calcium build up
Cold
Water
10
Advertisement
Table of Contents
