Table of Contents
Advertisement
Step 5: Connect waterlines to main valve
Step 6: Flush faucet
L
7
Attach waterlines to angle stops
and tighten until snug. Turn on angles
stops and check for leaks (DO NOT TURN
FAUCET ON)
Cold
Hot
Open
NOTE
are installed before connecting to
the main valve.
Important: After installation is complete,
remove aerator with aerator key (L).
Turn on water supply and allow both hot
and cold water to run for at least one minute
each. While water is running, check for leaks.
that could cause damage to internal parts.
Advertisement
Table of Contents
