Troubleshooting - Kraus Bolden KFF-1610 Installation Manual

Troubleshooting

If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
PROBLEM
Leakage under the handle.
The aerator has an irregular
or reduced water flow.
Water will not shut off
completely.
There is a low flow of water.
10
CAUSE
Bonnet nut (7) has come
10 loose.
9
11
The aerator is dirty or
misfitted.
12
Cartridge may need to be
adjusted or replaced.
The filter washers in the
hose connectors are dirty.
Close
90°
25°
Left
Open
Hot Water
Hexagon Nut
13
ACTION
Remove the index (11). Loosen set screw
(10) with hex wrench (21). Remove the
handle (9). Unscrew cap (8) (by hand only).
Tighten bonnet nut (7) with an adjustable
wrench.
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
Remove the index (11). Loosen set screw
(10) with hex wrench (21). Remove the
handle (9). Unscrew cap (8) (by hand
only). Loosen the bonnet nut (7) with an
adjustable wrench. Remove the cartridge
(6). Check for cracks.
Hot Cold
Water Water
Turn off the water supply at the water
valves and unscrew the hose connectors
from the water supply lines. Clean the
filter washers in the water lines with hot
water, removing any debris or calcium
build up.
Push