Table of Contents
Advertisement
Sensor Fault Display
Controller Status
Information Display
Configuration Parameters
Web-site: www.produal.com
Enquiries: T: +358 10 219 9100 E: info@produal.fi
If Sensor >=Amber Threshold; Alarm = Amber
If Sensor >= Red Threshold; Alarm = Red
Hysteresis acts to prevent a return to a lower alarm level until the Sensor value falls to a Threshold -
Hysteresis
LOW LIMIT ALARM
If the Amber threshold is set higher than the Red Threshold then:
If Sensor <= Amber Threshold; = Amber
If Sensor <= Red Threshold; Alarm = Red
Hysteresis acts to prevent a return to a lower alarm level until the Sensor value rises to a Threshold +
Hysteresis.
When entering FURTHER
INFORMATION AND SETTINGS
screen and a sensor/input fault is
active, select the fault icon for more
information.
The typical alarm reasons are:
•
External sensor 1 (Res1) fault
(when activated; out of range)
•
External sensor 2 (Res1) fault
(when activated; out of range)
•
Built-in sensor fault
•
Digital Input Alarm
After entering CONFIGURATION
PARAMETER GROUP screen and
selecting the INFO icon it is possible
to see the current status information
of the controller. The page shows the
current measurement and output
information.
ENTER MAINTENANCE CODE FOR
MAINTENANCE MODE
Maintenance Code
Enter Code
6666
7
8 9
4
5 6 -
1
2 3
Esc
0
Del
OK
The TRC-P devices are configured to operate in different modes via the configuration parameters
accessible through the maintenance mode.
To enter the maintenance mode click the COG WHEEL icon in the FURTHER SETTINGS SCREEN
and enter the maintenance mode password (default 6666).
FURTHER SETTINGS AND
INFORMATION
LIVE INFORMATION
SCREEN
Parameter Groups
Control Settings
Measurements
Operating Modes
Display
Network
CLICK TO ACCESS SETTINGS
GROUP
Parameter Groups
Control Settings
Inputs & Outputs
Fan, Boost, Lights & Blinds
Alarms
System
Copyright © 2020 Produal Oy - All rights reserved - 07/2020
Produal Oy
SELECT FAULT ICON FOR MORE
INFORMATION
Notifications
Internal Sensor Failure
Remote Sensor 1 Fault
Remote Sensor 2 Fault
Digital Contact Fault
Status Information
Built-In Sensor
RI_1
12.8
RI_2
--.-
DI_1
On
CO2
1200
Humidity
51.7
Target
21.7
Heating Demand
78
Cooling Demand
0
Fan Demand
78
CO2 Demand
65
Humidity Demand
12
De-Hum Demand
0
AO1
78
AO2
65
AO3
12
SELECT INFO ICON FOR
CLICK TO CHANGE
SETTING
Control Settings
Nominal Setpoint
21.0
Heating DZ COMFROT
0.5
Cooling DZ COMFORT
0.5
ACCESS
MORE
SETTINGS
Heating DZ ECO
4.0
PS 6001TRC-P - 17/34
24.8
Advertisement
Table of Contents
