Operation Overview - tams elektronik LD-G-24 Manual

English

Operation overview

The decoder LD-G-24 is designed for operation in DCC format and can be
adjusted to one of 127 basic addresses or to one of 10.239 extended
addresses. It is designed to be controlled from digital control units that
are set on the 14-, 28- or the 128-speed mode.
The decoder can be programmed individually by setting the
configuration variables. It is possible to set all configuration variables
with central units which support the CV-programming. With central
units which only support the so-called register-programming the
number of the configuration variables that can be set is restricted.
Automatic recognition of the analogue mode
The decoder can also be used in analogue model railway layouts run with
a D.C. speed control. When putting the locomotive on the rails the decoder
recognizes automatically if it is run in analogue or digital mode and sets
the corresponding operation mode. The automatic recognition of the
analogue mode can be switched off by programming the decoder
accordingly.
The decoder is not suitable for analogue model railway layouts run with an
A.C. speed control.
The lighting is always switched on according to the direction of travel.
Switching on or off the lighting and the additional functions is not
possible.
The configuration variables of the LD-G-24
The following configuration variables (CVs) can be set from the digital
control unit:
§
Basic address (CV#1)
§
Starting voltage (CV#2)
§
Acceleration rate (CV#3)
§
Braking rate (CV#4)
Page 30
LD-G-24