Improvement Of The Driving Characteristics; Faq - tams elektronik LD-G-24 Manual

English

Improvement of the driving characteristics

Locomotives with especially high current consumption or track sections
with bad contacts (e.g. some types of points) may give an
unsatisfactory
performance by soldering a capacitor 100 µF / 35 V between X8 and
X15 (see fig. 1 and 3).

FAQ

§
Parts are getting very hot and/or start to smoke.
Tip: The deocder may warm up to 45 °C in operation. This does not
affect the functioning of the decoder.
!
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: The connection of the motor is connected to locomotive
ground. à Disconnect the connection from locomotive ground.
§
The lighting goes on and off when the speed levels are turned up
or the lighting cannot be switched on or off.
Possible cause: The speed mode of the decoder and the digital control
unit do not correspond. Example: The central is set to the mode 28
speed levels, but the decoder to the mode 14 speed levels. à Change
the speed mode at the central and / or at the decoder.
§
The locomotive does not run in analogue mode.
Possible cause: The analogue mode is switched off. à Alter the value
for CV #29.
Possible cause: The analogue model railway layout is run with a A.C.
speed control, the analogue mode however is only possible with
D.C. speed controls.
Page 44
performance. You can improve
LD-G-24
the locomotive