tams elektronik LD-G-24 Manual page 15

LD-G-24 English
Solder the connections from the rail current collectors at the points X1
and X2. Next solder the connections from the motor at the points X11
and X12. In case the locomotive´s direction of motion in analogue
mode does not match the direction of motion set at the speed control
you have to swap the connections to the points X11 and X12.
Connecting the lighting and other accessories
Before connecting the accessories check if the current is below the
maximum permissible value of 1.000 mA. If lightings or other
accessories with a current of more than 1.000 mA are connected the
decoder will be damaged when put into operation. Please note that the
maximum total current for motor and accessories should not exceed
3.000 mA.
Disconnect any existing diodes in the leads to the lamps. Connect the
lamps and the other accessories to the function outputs X4 to X7. The
assignment of the function outputs to the function keys will be made
when programming the decoder. If the lamp or the accessory is already
connected with one side to locomotive ground, the connection is
complete. If not, connect the second side of the lamp or the accessory
to the return conductor of the decoder (point X3).
If you want to use the decoder factory settings, you have to connect
the lighting and the accessories as follows:
Front lighting: X4
Back lighting: X5
Accessory to be switched via F1: X7
Accessory to be switched via F2: X6
!
Caution:
If you connect the loads to the return conductor for all functions (point
X3), the loads must be insulated. The loads should not make contact
with metal parts of the locomotive. Possible short circuit! The
locomotive decoder will be damaged in operation.
Page 37