MotorGuide Xi3-70 SW GPS Operation, Maintenance & Installation Manual page 37

MAINTENANCE AND STORAGE
NOTE: Replace the propeller pin if it is bent.
INSTALLING THE PROPELLER
1. Rotate the motor shaft to insert the propeller pin horizontally.
44664
2. Install the propeller onto the motor shaft by engaging the propeller onto
the propeller pin.
3. Install the washer (and anode, for saltwater models) onto the propeller
shaft, then install the propeller nut. Use a wrench or a socket and ratchet
to tighten the propeller nut until it is snug, then tighten the nut another 1/4
turn.
eng
a - Propeller pin
a
53442
57326
31