MotorGuide Xi3-70 SW GPS Operation, Maintenance & Installation Manual page 20

PRODUCT INSTALLATION, WIRING, AND BATTERY
3. Connect the negative (–) trolling motor lead to the negative (–) trolling
motor battery terminal.
a
b
24-VOLT BATTERY CONNECTION
1. Install a 50‑amp (good) or 60‑amp (best) manual reset circuit breaker in
line with the trolling motor power cable positive (+) lead and the trolling
motor battery B positive (+) terminal.
2. Connect the positive (+) trolling motor lead to the positive (+) terminal on
trolling motor battery B.
3. Connect a jumper wire (reference gray) between the negative (–) terminal
on battery B to the positive (+) terminal on battery A.
IMPORTANT: The jumper wire should be the same wire gauge as the
negative (–) and positive (+) power cables.
4. Connect the trolling motor negative (–) lead to the negative (–) terminal on
battery A.
INFORMATION
c
64893
12–volt battery connection
a - Power cables to trolling motor
b - Manual reset circuit breaker
c - Trolling motor battery
14
eng