MotorGuide Xi3-70 SW GPS Operation, Maintenance & Installation Manual page 32

TROLLING MOTOR OPERATION
• The Sleep Mode state can start when the trolling motor is in the stowed or
deployed position.
• Wake the trolling motor from Sleep Mode by pressing any button on the
FOB or wireless foot pedal (sold separately).
• The next button pressed will activate the trolling motor and perform the
intended button function. Once the motor is activated all the functions will
operate normally.
STEERING
•
To turn left, press the left turn button on the handheld remote.
•
To turn right, press the right turn button on the handheld remote.
• The available steering range allows the trolling motor to turn beyond 360°
for operation in reverse. Take care not to stress the cables when rotating
the trolling motor beyond 360°.
SPEED CONTROL
•
Press the propeller on/off button once to start the propeller, and press
the propeller on/off button again to stop the propeller.
• The trolling motor will emit a single ascending‑tone beep when the
propeller is turned on and a single descending‑tone beep when the
propeller is turned off.
• The system is equipped with 20 speed levels. Press and release the
increase speed (+) button to increase motor speed by one level. Press
and release the decrease speed (–) button to reduce motor speed by one
level.
•
Holding the increase speed (+) or decrease speed (–) will cause the
speed level to increase or decrease until the speed level limit is reached.
Holding the increase speed (+) or decrease speed (–) button for 2.5
seconds will ramp up the speed level from 0% to 100%, or decrease from
100% to 0%, respectively. The trolling motor will emit two beeps when it
reaches the 100% or 0% speed level.
26
eng