Documents Which Also Apply; Warranty; Declaration Of Conformity; Welding In Environments With Increased Electrical Hazards - EWM Pico 160 Operating Instructions Manual

Intended use

Documents which also apply

3.2 Documents which also apply
3.2.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.2.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
The manufacturer recommends carrying out the safety inspection according to national and in-
ternational standards and guidelines every 12 months.
3.2.3

Welding in environments with increased electrical hazards

Power sources with this marking can be used for welding in an environment with increased
electrical hazard (e.g. boilers). For this purpose, appropriate national or international regulations
must be followed. The power source must not be placed in the danger zone!
3.2.4

Calibration/Validation

An original certificate is enclosed with the product. The manufacturer recommends calibration / validation
at intervals of 12 months.
3.2.5

Part of the complete documentation

These operating instructions are part of the complete documentation and valid only in
combination with the "Safety instructions"!
Read and observe the documents for all system components!
Item Documentation
A.1 Safety instructions
A.2
Power source
A.3 Welding torch / Electrode holder
A Complete documentation
14
Figure 3-1
099-002128-EW501
26.01.2022