Table of Contents
Advertisement
NETWORK AUDIO OVERVIEW
CHANGE THE IR CODE
IR Code (DMS-550/600 only). If your IR remote control shares common Phillips RC-50 codes
with your other products, such as volume control, power, etc., you can change the command codes
in the IR remote and DMS-550/600 as follows. The default settings are IR Code A (Blue Power
LED). To change, follow these steps.
Select
1.
IR Code and
Highlight
2.
IR Code A (Red Power LED) and
You'll notice the IR remote no longer works after change the setting in the DMS. You now need to
match the IR remote codes to the same IR Code set of the DMS.
Press and hold
3.
the Menu button of the IR remote
RED
. Now the DMS and IR remote control IR Codes will match with the DMS and should not
interfere with your other electronics. To switch back, simple repeat processes in steps 1-3 to IR
Code A (Blue Power LED).
press
the right arrow key.
press
Enter on the IR remote.
for 5 seconds until the Power button flashes
25
Advertisement
Table of Contents
