Change The Ir Code; Factory Reset - Cary Audio Design DMS-650 Owner's Manual

Network audio player

Hide thumbs Also See for DMS-650:

Table of Contents

CHANGE THE IR CODE

If your IR remote control shares common Phillips RC-50 codes with your other products, such as volume control, power,

etc., you can change the command codes in the IR remote and DMS-650 as follows. The default settings are IR Code A

(Blue Power LED). To change, follow these steps.

Select IR Code and press the right arrow key.

Highlight IR Code A (Red Power LED) and press Enter on the IR remote.

You will notice the IR remote no longer works after change the setting in the DMS-650. You now need to match the IR

remote codes to the same IR Code set of the DMS.

Press and hold the Menu button on the IR remote for 5 seconds until the Power button flashes RED. Now the DMS and IR

remote control IR Codes will match with the DMS and should not interfere with your other electronics. To switch back,

simple repeat processes in steps 1-3 to IR Code A (Blue Power LED). Resetting the DMS-650 defaults back to Code A/Blue.

This Resets the DMS-650 to factory default. If at any time the DMS-650 is not functioning normally, it is recommended to do

a Factory Reset. To go one step further, unplug the DMS-650 after the Factory Reset is complete for 10 minutes then plug

the DMS-650 back in. Wait another 5 minutes before turning the DMS-650 back on. While it is unplugged, you can also

delete and reinstall the Cary Audio Streamer 2.0 app. All settings will default to factory, requiring reconnecting to network

as well as re-indexing of connected USB HDDs and SD cards and reset all other system defaults.

Table of Contents