Change The Ir Code; Factory Reset - Cary Audio Design DMS-800 Owner's Manual

Network audio player

Hide thumbs Also See for DMS-800:

Table of Contents

CHANGE THE IR CODE

If your IR remote control shares common Phillips RC-50 codes with your other products, such as volume control, power,

etc., you can change the command codes in the IR remote and DMS-800PV as follows. The default settings are IR Code A

(Blue Power LED). To change, follow these steps.

Select IR Code and press the right arrow key.

Highlight IR Code A (Red Power LED) and press Enter on the IR remote.

You will notice that the IR remote no longer works after changing the setting in the DMS-800PV. You now need to match

the IR remote codes to the same IR Code set of the DMS.

Press and hold the Menu button on the IR remote for 5 seconds until the Power button flashes RED. Now the DMS and IR

remote control IR Codes will match with the DMS and should not interfere with your other electronics. To switch back,

simply repeat processes in steps 1-3 to IR Code A (Blue Power LED). Resetting the DMS-800PV defaults back to Code A/Blue.

This Resets the DMS-800PV to factory default. If at any time the DMS-800PV is not functioning normally, it is recommended

to do a Factory Reset. To go one step further, unplug the DMS-800PV after the Factory Reset is complete for 10 minutes,

then plug the DMS-800PV back in. Wait another 5 minutes before turning the DMS-800PV back on. While it is unplugged,

you can also delete and reinstall the Cary Audio Streamer 2.0 app. All settings will default to the factory settings, requiring

reconnecting to the network as well as re-indexing of connected USB HDDs and SD cards and resetting all other system

defaults.

Table of Contents