Duress Alarm Parameters - ZKTeco F18I User Manual

2.4 inch color screen series User Manual
Press ▲/▼to move cursor to the item to be set. If it is the input box,
press numeric keys on small keyboard to input the value. If it is the roll
box, press / to switch values. After setting, press Menu directly to
return to the last interface. Press "ESC" to cancel setting and return to
the last interface.

2.4.6 Duress Alarm Parameters

There is duress alarm parameter setting in the device. When employee
come across duress, select duress alarm mode, the device will open the
door as usual. But the alarm signal will be sent to the alarm.
Help key: If select "Yes", press help then press fingerprint in the
following 3 seconds or press ID number, and duress alarm will come out
after successful identification. If select "No", it is useless to press help.
（help can be set in keyboard definition.)
1:1 Trig: if select "Yes", when user use 1:1 match mode, alarm signal
will come out. Or there is no alarm signal.
1: N Trig: if select "Yes", when user use 1: N match mode, alarm signal
will come out. Or there is no alarm signal.
Pwd Trig: If select "Yes", when user use password verification mode,
alarm signal will come out. Or there is no alarm signal.
Alarm delay: After duress alarm gets started, the alarm signal is not
output directly. But it can be defined. After some time, alarm signal will
be generated automatically.（0-255 seconds) 。
Operation:：
Press Menu -> User Management -> Access Setting -> Duress alarm
parameters (as shown below).
- 42 -