Page 1
Quick Start Guide FaceKiosk-H13A/C Version: 2.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
1. Device Overview Wall Mount Facekiosk-H13A Near Infrared Camera Visible Light Camera LED Fill Light Near Infrared Fill Light Speaker RFID Card Reading Area Fingerprint Scanner 13.3-inch High-definition Capacitive Touch Screen...
Page 3
Floor Mount Facekiosk-H13C Visible Light Camera Near Infrared Camera LED Fill Light Near Infrared Fill Light 13.3-inch High-definition CapacitiveTouch Screen Speaker Fingerprint Scanner RFID Card Reading Area QR Code Scanner Ticket Printer...
Page 4
2. Facekiosk Installation Wall Mount Installation Procedure Before installation, connect the wire to the device and pass it through the lower aperture of the device. Align the back plate with respect to the screw holes on the back of the device. Secure the plate with the screws (11 pcs) to the back of the unit.
Page 5
Set the device in an appropriate position on the rear panel that is fixed on the wall. Secure the Kiosk by assembling the device and the rear panel with the bottom screws.
Page 6
Floor Mount Installation Procedure Take the device and the base from the box, and insert the device into the corresponding slot of the base plate. Cautiously incline the device in a horizontal position and assemble the device over the base with the screws (8 pcs) from the bottom of the base.
Page 7
3. Door Sensor, Exit Button & Alarm Connection 4. Access Control Device Connection...
5. Quick Start User Registration Management View records Verification Registration Device Registration: Tap Menu > Staff Management> New Staff for new user registration. Enter the mandator y registration details (ID, First name, Face registration) and then tap Next to select the verification mode (face, fingerprint, access card number (RFID card).
Page 9
Software Registration : Set the IP address and the cloud service server address on the device before registering into the software. Biotime Software Registration: 1. If the device is set with server address and port number the device will be automatically added to the software. 2.
Page 10
Mobile Phone Registration: Scan the QR Code using the mobile phone and register the face. Note: Only the super administrator is entitled to access the main menu of the system. Advised to set up or install the device terminal at the indoors without sunlight interference.
Page 11
Upload Data to the Back-end Software Main Menu->Communication setting, Communication Settings allows you to upload or transmit user data from devices like computer, laptop and more. Communication Settings Ethernet setting: Connects the device to the computer via Ethernet. Cloud server setting: Connects the device to the server. U Disk Management Tap U Disk Management on the main menu to manage USB drivers.