Operations; Test Run; General - Grizzly G1061 Instruction Manual

SECTION 6: OPERATIONS
Keep
rolled up and out of the
way of machinery and
keep hair pulled back.
!
Disconnect power to the
machine when perform-
ing
assembly
ments. Failure to do this
may result in serious per-
sonal injury.
Wear safety glasses dur-
ing the entire operation
process. Failure to com-
ply may result in serious
personal injury.
Using this machine pro-
duces sawdust which may
cause allergic reactions
and respiratory problems.
Use an approved dust
mask to protect yourself
from these hazards!
NOTICE
The following section was designed to give
instructions on the basic operations of this
buffer. However, it is in no way comprehen-
sive of every buffer application. There are
many different buffing wheels, sanding
drums and attachments available for buffers.
WE STRONGLY RECOMMEND that you read
books, trade magazines, or get formal train-
ing to maximize the potential of your
machine.
-8-
loose clothing
any maintenance,
or adjust-

Test Run

Once mounting is complete and adjustments are
done to your satisfaction, you are ready to test
the machine.
Turn on the power supply at the main panel.
Make sure that your hand is poised near the
switch in case there is a problem. The buffer
should run smoothly with little or no vibration or
rubbing noises. Strange or unnatural noises
should be investigated and corrected before
operating the machine further.
If you cannot easily locate the source of an
unusual noise or vibration, feel free to contact our
service department for help.

General

The Model G1061/G1061Z Buffing System is
strictly designed for buffing and sanding opera-
tions. IT IS NOT A GRINDER. The absence of
grinding wheel guards prohibit the use of this
machine as a grinder.
This buffer has a left and right shaft to provide the
option of mounting two different sanding or buffing
accessories, depending on your application. The
convenience of having two shafts allows you to
mount different grits of sandpaper or different tex-
tured buffing wheels onto each shaft.
G1061/G1061Z Buffing System