Section 4: Operations; Operation Overview - Grizzly G0936 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Model G0936 (Mfd. Since 06/21)
manual BEFORE
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To complete a typical operation, the operator
does the following:
1.
Examines the workpiece to verify it is suitable
for sanding.
2.
Prepares and trims workpiece as necessary.
3.
Installs sanding belt with appropriate grit for
operation.
4. Adjusts platen tilt as desired, then adjusts
table to allow maximum
between table and sandpaper.
5. Ties back loose hair and clothing, and puts
on safety glasses and respirator. Takes all
other required safety precautions.
6. Starts dust collector and then sander.
7. With both hands, holds workpiece firmly
against table and miter gauge (if used), eases
workpiece into sanding belt, and moves
workpiece back and forth to wear sandpaper
evenly and prevent overheating.
8. Turns machine and dust collector OFF.
⁄ " clearance
1
16
-17-