Section 4: Operations; Operation Overview - Grizzly G0634X Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0634X (Mfd. Since 11/20)
manual BEFORE
Typical Jointing Operation
Operator examines workpiece to verify it is
1.
safe and suitable for jointing.
Ensures jointer tables are secured in DOWN
2.
position, and jointer/planer selection lever is
set for jointing operations.
Adjusts fence for width of workpiece and
3.
locks it in place.
Adjusts fence tilt, if necessary.
4.
Adjusts infeed table height to set depth of cut
5.
per pass.
Puts on safety glasses, respirator, and any
6.
other required protective equipment.
Starts jointer.
7.
Using push blocks as needed, holds
8.
workpiece firmly against infeed table and
fence, and feeds workpiece into cutterhead
at steady and controlled rate until entire
length of workpiece has been cut and it clears
cutterhead on outfeed table side.
Repeats cutting process described above
9.
until desired results are achieved.
10. Stops jointer.
-23-