Table of Contents
Advertisement
ECR 465T-F/466T-F
13. FLASH-PROGRAM „S" MODE
You can use this to transfer new firmware to the cash register, exchanging an e-prom is therefore no longer
necessary.
This programme can only be run by a specialized dealer in the Olympia-SERD Manager.
1. Pull the mains cable
2. Set the key position on the cash register to
3. Plug in the mains cable.
4. On DISPLAY :
On DISPLAY :
On DISPLAY :
On DISPLAY :
5. The cash register is now ready to receive new software.
6. Now start the OLYMPIA-SERD - Manager on your PC
7. Open either an already available or new file
8. Open the folder Flash Programming
9. Open the folder download a new firmware and activate "Send Firmware to the ECR". Wait until the data
is saved in the new MOT file (Firmware) and activate it. Follow the instructions on the screen, the new
firmware is loaded and sent automatically to the cash register.
10. End the PC mode on the cash register by pressing the
mains cable, turning the cash register to "REG" and plugging the mains cable back in. The programmed data
on the cash register is retained.
_____________Programming Instruction___________________________________
"S"
Date-- Time—FML=actuell Firmwareversion
HIT CASH confirm with the
LOAD FLASH MEMORY confirm with the
FACTORY TEST
OPEN PORTS confirm with the
RUN FLASH PROGRAM
PORTS OPENED
[
]
Key.
[
[
]
Key.
[
Page
]
Key.
]
key twice, pulling the
66
Advertisement
Table of Contents
