Olympia ECR 465T-F Programming Instructions Manual page 43

Page
43
ECR 465T-F/466T-F _____________Programming Instruction___________________________________
Section 24 1. change the standard pressure texts
The change of the register texts can be made only about the PC program.
1st we the language changed in the S mode with 10 [#/NS], be able to want to receive the Standardrexte in the oriented
language into the section's texts (#24).
The texts can be then changed and sent to the register again.
In the PC program this table is reported to you.
Section message 28II
( look at page 12 )
All standard pressure message and change Section 28 II for the display advertisement
Note: Message 28 II only can be sent to the register if the register stands on off lock-position.
A table becomes all 2. in the section's „message II 28" for message these are used in the register shown
all 4 languages are subdivided into pressure and LCD display listed with all message for you have the possibility
to adapt the voucher message and the message to the display advertisement here individually.
In the PC program this table is reported to you.
You must change the message 28II for every model sperat ECR 465 and ECR 466.