Installation Options - Honeywell Home TH8110R1008/U Manual

®
VISIONPRO 8000 WITH REDLINK™

INSTALLATION OPTIONS

The VisionPRO® 8000 with RedLINK™ system can be wired directly to the equipment, used with an Equipment Interface
Module, or with a TrueZONE wireless adapter.
If using the Equipment Interface Module, see "Installing Equipment Interface Module (if used)" on page 9.
If using a TrueZONE wireless adapter, follow the installation instructions that came with the TrueZONE panel, and go to
"Selecting Thermostat Location" beginning on page 11.
Wired Directly to Equipment
Dual Powered - C Wire or Battery
(C wire or C-wire Adapter required to use RedLINK accessories)
RedLINK to Equipment Interface Module
2 Wires for Power or
Battery Only (no wires)
RedLINK to TrueZONE Wireless Adapter
2 Wires for Power or
Battery Only (no wires)
Model Numbering
Stages
Residential or Commercial
Dual Powered - C Wire or Battery
Onboard Humidity Sensor
Number of IAQ Relays
Number of Sensor Inputs
Economizer / TOD Output
Works with Optional Equipment Interface Module*
Works with Optional TrueZONE Wireless Adapter*
* The relay outputs and inputs on the thermostat do not function when used with an Equipment Interface Module or the
TrueZONE Wireless Adapter.
* If the thermostat has been setup WITHOUT an Equipment Interface Module or the TrueZONE Wireless Adapter and you
would like to add one, you must reset the thermostat back to factory defaults. Press MENU > Installer Options > scroll
down to select Reset to Defaults.
68-0312—07
OR
TM
OR
TM
Fig. 5. VisionPRO® 8000 with RedLINK™ installation options.
TH8321 TH8320
3H/2C HP 3H/2C HP
2H/2C CONV 2H/2C CONV



1
1



8
MCR37817A
TH8110
1H/1C HP
1H/1C CONV
 
 
0 0
1 1

 
 