Usb Ports - DFI KD632-Q170 User Manual

USB Ports

USB 6
USB 5
USB 2.0
USB 4 USB 2
USB 3 USB 1
USB 3.1 Gen1
PWR
RX-
PWR
RX+
RX-
USB 5-6
RX+ GND
GND TX-
TX+
TX-
TX+
GND
GND DATA-
Vertical USB 9
DATA+
DATA-
DATA+ NC
USB 3.1 Gen1
USB 2.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with 3 onboard USB 2.0 ports (USB 5-6/9) and 4 onboard USB
3.1 Gen1 ports (USB 1-2/3-4). The 10-pin connectors allow you to connect 4 additional USB
2.0 ports (USB 7-8/13-14). The 20-pin connector allows you to connect 2 additional USB 3.1
Gen1 ports (USB 5-6). The additional USB ports may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the system chassis and then
insert the USB port cables to a connector.
BIOS Setting
Configure these USB devices in the Advanced menu ("USB Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system's manual or documentation for more information.
Chapter 2 Hardware Installation
19
Battery
USB 13-14
10
2
1
9
USB 7-8
USB 2.0
Chapter 2
Jumper Settings
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state.
• BIOS Setting
Configure the wake-up function of USB in the Advanced menu ("ACPI Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
1
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
1
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
23
www.dfi.com