DFI KD632-Q170 User Manual page 41

Debug Configuration
This section configures debug setting.
InsydeH2O Setup Utility
Advanced
Dynamic EFI DEBUG <Off>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM
port. If set to on, relevant EFI debug information will show up.
InsydeH2O Setup Utility
Advanced
Dynamic EFI DEBUG <On>
EFI debug print level [0x80000000]
EFI debug serial port [0x3F8]
EFI debug baud rate [115200]
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Chapter 3 BIOS Setup
Rev. 5.0
Enable it to output debug
message from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
Enable it to output debug
message from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Chapter 3
UEFI Device Manager
The section configures UEFI device with option ROM, such as LAN card, etc.
Advanced
UEFI Device Manager
UEFI Device Manager
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
41
InsydeH2O Setup Utility
UEFI Device Manager
Setting
Exit BIOS Setup Utility and launch Device Manager !!
[OK]
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
www.dfi.com