DFI KD632-Q170 User Manual page 37

SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
installed in your system unit.
InsydeH2O Setup Utility
Advanced
SATA Controller(s)
SATA Speed
SATA Mode Selection
System Acceleration with Intel(R)
Optane(TM) Memory
SATA0 (R2) [Not Installed]
Port 0
Hot Plug
SATA1 (R3) [Not Installed]
Port 1
Hot Plug
SATA2 (R4)
[Not Installed]
Port 2
Hot Plug
SATA3 (R5) [Not Installed]
Port 3
Hot Plug
SATA4 (R1) [Not Installed]
Port 4
Hot Plug
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
SATA Controller(s)
This field is used to enable or disable Serial ATA devices.
SATA Speed
This field is used to select SATA speed generation limit: Auto, Gen1, Gen2 or Gen3.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
Intel RST Premium
This option allows you to create RAID or Intel Rapid Storage configuration on Serial
ATA devices.
System Acceleration with Intel(R) Optane(TM) Memory (KD632-C236 only)
This field is used to enable or disable the system acceleration with Intel
memory feature.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable/Disable SATA
<Enabled>
Device.
<Auto>
<AHCI>
<Enabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Optane
® ™
Port 0/1/2/3/4 and Hot Plug
These fields are used to enable or disable the serial ATA port and its hot plug.
37
www.dfi.com