Graphics Interfaces - DFI KD632-Q170 User Manual

Graphics Interfaces

The display ports consist of the following:
• 1 VGA port
• 1 DVI-I (DVI-D signal) port
• 1 DP++ port
VGA
DVI-I
(DVI-D signal)
DP++
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
DVI-I (DVI-D Signal) Port
The DVI-I port is used to connect a digital LCD monitor or LCD TV. This port supports DVI-D
signal only. Connect the display device's cable connector to the port. After you plug the cable
connector into the port, gently tighten the cable screws to hold the connector in place.
DP++ Port
The DP++ port which carries both digital audio and video signals is used to connect a LCD
monitor or a digital TV that has the DP++ port.
Chapter 2 Hardware Installation
Chapter 2
BIOS Setting
Configure the display devices in the Advanced menu ("Video Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to the chapter 4 for more information.
19
Battery
1
1
22
www.dfi.com