Figure 99. Installing the MicroSD card
Next steps
1.
Install the IDSDM module.
2. Follow the procedure listed in
LOM riser card
Removing the LOM riser card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the rear drive
5.
Remove the expansion card
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the LOM riser card to the system board.
2. Push the retention clips to release the LOM riser card.
3. Hold the LOM riser card by the edges and lift to disconnect the card from the connector on the system board.
4. Slide the LOM riser card towards the front of the system to disengage the ports from the slot.
After working inside your system
Safety instructions
Before working inside your system
cage.
riser.
on page 27.
on page 26.
on page 27.
Installing and removing system components
95