Lom Riser Card - Dell E56S Series Installation And Service Manual

Figure 96. Installing the MicroSD card
Next steps
1. Install the IDSDM or vFlash module
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in

LOM riser card

Removing the LOM riser card
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the
Steps
1. Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2. Release the two blue plastic clips holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
all drives, and then close the drive
units.
After working inside your
Safety Instructions.
all drives, and then close the drive
units.
.
risers.
bays.
system.
bays.
Installing and removing system components 107