Cooling Fan; Removing A Cooling Fan - Dell EMC PowerEdge R7515 Installation And Service Manual

Cooling fan

Removing a cooling fan

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Disconnect the cooling fan cable from the system board connector.
2. Remove the cable from the cable retention tabs.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Press the release tab, and lift the cooling fan from the cooling fan cage.
NOTE: The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
Figure 27. Removing a fan
NOTE: Ensure to disconnect the cooling fan 1 cable from the connector on the power interposer board.
Safety instructions
Before working inside your system
on page 26.
on page 27.
Installing and removing system components 37