Installing The Microsd Card - Dell EMC PowerEdge R7515 Installation And Service Manual

Figure 98. Removing the MicroSD card
Next steps
1. Replace the MicroSD

Installing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the IDSDM module.
NOTE: To use a MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on
the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
94 Installing and removing system components
cards.
Safety instructions
Before working inside your system
on page 26.
on page 27.
System board jumpers and connectors section.