Figure 75. Installing an expansion card on the system board
Next steps
1. Connect the required cables to the expansion card.
2. If removed,
install the rear drive
3.
Install the air
shroud.
4. Follow the procedure listed in
Removing an expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect any cables that are connected to the expansion card or expansion card riser.
4.
Remove the air
shroud.
5.
Remove the expansion card
NOTE:
The procedure to remove expansion card from riser 1A, riser 2, or riser 1B is identical.
Steps
1. Pull and lift to open the expansion card retention latch.
2. Hold the expansion card by its edges, and pull the card from the expansion card connector on the riser.
cage.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 27.
on page 26.
on page 27.
Installing and removing system components
79