Installing The Sd Vflash Card; Lan On Motherboard (Lom) Riser Card; Removing The Lom Riser Card - Dell PowerEdge FC430 Owner's Manual

Next steps
Follow the procedure listed in

Installing the SD vFlash card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in
System Setup.
Steps
1. Locate the SD card connector on the internal dual SD module. Align the SD card appropriately and
insert the contact-pin end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
Next steps
1. Follow the procedure listed in

LAN on Motherboard (LOM) riser card

The LOM riser card installed in your system is an integrated network interface controller. You can remove
and install the LOM riser card.

Removing the LOM riser card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Remove the two screws that secure the LOM riser card to the system board.
2. Lift the card from the system board.
After working inside your
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.
system.
57