Installing The Processor - Dell EMC PowerEdge R7515 Installation And Service Manual

Installing the processor

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the heat sink.
5. If the processor has previously been used in a system, remove any remaining thermal grease from the processor by using a
lint-free cloth.
6. Use the thermal grease syringe included with your processor kit to apply the grease in a quadrilateral design on the top of
the processor.
CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and
contaminating the processor socket.
NOTE: The thermal grease syringe is intended for single use only. Dispose the syringe after you use it.
Steps
1. Holding the blue tab on the processor tray, slide the tray into the processor socket rail frame until firmly seated.
Figure 61. Placing the processor tray into the rail frame
2. Push the rail frame down until the blue latches lock into place.
Safety instructions
Before working inside your system
on page 26.
on page 27.
Installing and removing system components 65