Lom Riser Card; Removing The Lom Riser Card - Dell EMC PowerEdge R440 Installation And Service Manual

Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2 Align IDSDM/vFlash card with the connector on the system board.
3 Push IDSDM/vFlash card until it is firmly seated on the system board.
Figure 65. Installing optional IDSDM/vFlash card
Next steps
1 Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2 Follow the procedure listed in

LOM riser card

The LOM riser card is a small, removable mezzanine card, which provides the flexibility of selecting different network connectivity options.

Removing the LOM riser card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 If installed, remove the LP or FHX1.
78 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.