Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Intrusion switch module
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable connector from connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
Figure 31. Removing the intrusion switch
Next steps
1.
Replace the intrusion
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
40
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
switch.
Safety instructions
Before working inside your system
on page 27.
on page 26.
on page 27.
on page 26.
on page 27.