Set The "Modbus Slave" Parameter; Set The "Modbus Master" Parameter; Set The "Uart Switch" Parameter - ICP DAS USA I-7530A-MR-G User Manual

Set the "Modbus Slave" parameter

3.2.6
When users select the "Modbus Slave" communication mode, the
functions, "Device ID" and "Specific CAN ID", are useful. In the "Specific
CAN ID" field, users can set maximum 10 CAN IDs (firmware v1.02 or
later supports 100 CAN ID of CAN messages). For more details about
Modbus Slave mode, please refer to the section 6.
Figure 3-13: The configuration for Modbus Slave mode.

Set the "Modbus Master" parameter

3.2.7
When users select the "Modbus Master" communication mode
(firmware v2.00 or later), the new configuration page will be pop-up. For
more details about Modbus Slave mode, please refer to the section 7.

Set the "Uart Switch" parameter

3.2.8
When users select the "Modbus Master" communication mode
(firmware v2.10 or later), the functions, "CAN-ID Length", "CAN-ID
Length" and "Direction" are useful. For more details about Modbus Slave
mode, please refer to the section 8.
Figure 3-14: The configuration for Uart Switch mode.
I-7530A-MR Modbus RTU to CAN Converter User's Manual (Version 1.08, 07/2019) ------------- 29