Table of Contents
Advertisement
RS232 Connection
1.
Set RS232 control method on Bottom Dip Switch. (See page 18).
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using. (See page 18).
3.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4.
Does not need setting camera address in way of RS232 controlling.
5.
Use the RJ45 to RS232 control connection cable (VISCA). The controller must be VISCA compatible.
6.
Camera supports Daisy Chain in RS232 control mode by using extension cables (Included). Have to use 8-Pin Mini Din
Serial RS232 Cable (Not included) connection for the controller. HDBaseT Receiver support RS232 daisy chain connection.
7.
You can make RS232 connection cable if you have the following applications:
Use RS-422(VISCA)/RS-485 (PELCO P/D)
You can use RS-422/485 port connect to optional controllers, such as joystick control keyboard, control PC station, to
operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform the Preset operation
using the control buttons.
An application software that supports this unit is needed if you use PC station.
13
Advertisement
Table of Contents
