Electro-Voice RE3-BP0L-T Instruction Manual page 7

RE3 UHF Wireless
NOTE: Regarding RE3-HHT-6M (653-663 MHz) and RE3-BPT-6M (653-663 MHz); use of
frequencies beginning at 653.000 MHz up to 657.000 MHz is covered under FCC Part 74 ID
numbers B5DH2286M and B5DB1246M, and require an LPAS user license, however use of
frequencies between 657.025 up to 663.000 MHz is covered under FCC Part 15, and do not
require an additional user license. For more information, see
https://www.fcc.gov/consumers/guides/operation-wireless-microphones.
FCC Supplier's Declaration of Conformity
47 CFR, Section 2.1077 Compliance
Product Identifier:
Electro-Voice:
RE3 Wireless Receiver, AASP Active Antenna Splitter, ALPA
Active Log Periodic Antenna, RFAMP Antenna Booster, BC2
Battery Charger
Responsible Party – U.S. Contact Information
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, NY 14450
USA
Tel: +1 (585) 223-4060
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not be
CAUTION: Changes or modification made by the user could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

1.4.2 IC (Industry Canada)
Electro-Voice
Information
Installation manual
Safety, precautions, and notices | en
2021.06 | 03 | F.01U.362.808
7