Table of Contents
Advertisement
en | RE3-BPT bodypack transmitter
48
3
Sync signal port
4
Battery alert LED
5
Power button
Battery door
6
latch/lock
7
Battery door
Battery
8
compartment
9
SET button
10 ▲ (up button)
11 ▼ (down button)
12 Mute switch
2021.06 | 3 | F.01U.362.808
When syncing the transmitter to the receiver, aim the
transmitter's unobstructed sync port directly toward the
receiver's sync emitter. A direct line of sight is required. Maintain
a distance between two inches and twelve inches (or between
5cm and 30cm) for best sync performance. The blue LED next to
the battery alert icon will flash blue during the sync operation and
will glow solid blue for three seconds when sync operation is
successful.
This is a multi-purpose status alert LED: Sync / battery low. Glows
solid red when battery low. Flashing blue while syncing. Solid
blue for three seconds when the transmitter is successfully
sync'd to the receiver.
This is a multi-purpose button, functioning as a power on and off
switch, as well as a menu escape switch.
To power ON transmitter: press briefly.
To power OFF transmitter: press and hold for three seconds.
Transmitter turns off.
While in parameter edit mode, press to escape to home screen.
CANCEL appears on the screen and no setting changes are
saved.
Slide the latch downward to unlock the battery door. Continue
pressing the latch downward while rotating the bottom-hinged
door downward to open the battery compartment door.
Covers and protects batteries.
Holds two AA or AA-size rechargeable cells. Install AA cells
according to polarity orientation as shown.
The most commonly used menu navigation button, it is a multi-
purpose action button which functions as an enter key, a menu
advance key, and a save or store key.
This menu navigation button adjusts the value of an editable
parameter. Pressing the ▲ button will increase the displayed
value of the current parameter, or the next state condition value
above the displayed state value.
This menu navigation button adjusts the value of an editable
parameter. Pressing the ▼ button will decrease the displayed
value of the current parameter, or the next state condition value
below the displayed state value.
This toggle switch engages mute / unmute function, and the
colored LED indicates statuses. Sliding the illuminated switch
into the mute position silences the audio. Sliding the illuminated
Installation manual
RE3 UHF Wireless
Electro-Voice
Advertisement
Table of Contents
