Table of Contents
Advertisement
en | RE3-RX receiver
22
4
SYNC button LED
5
SET button
6
Power button
▼ down button
7
▲ up button
8
LCD display
9
10 AF meter
11 RF meter
12 Antenna A jack
2021.06 | 3 | F.01U.362.808
A circular LED indicator surrounding the SYNC button. The LED
will rapidly flash green during the sync operation and will glow
solid green when sync operation is successful. The LED will
remain solid green after a successful sync operation. If sync fails,
the LED will flash green slowly and constantly until a successful
sync operation.
The most commonly used menu navigation button, it is a multi-
purpose action button which functions as an enter key, a menu
advance key, an item select key, and a save or store key.
Turns the receiver on or off. Press in to turn receiver on. Press in
again to turn receiver off.
This is a dual-purpose menu navigation button.
As a menu scroll button, press to scroll downward through main
menu items.
As an editable parameter value adjuster, pressing the ▼ button
will decrease the displayed value of the current parameter, or the
next state condition value below the displayed state value.
Pressing while displaying main operating menu decreases audio
output level.
This is a dual-purpose menu navigation button.
As a menu scroll button, press to scroll upward through main
menu items.
As an editable parameter value adjuster, pressing the ▲ button
will increase the displayed value of the current parameter, or the
next state condition value above the displayed state value.
Pressing while displaying main operating menu increases audio
output level.
Backlit LCD displays all operating information and menus.
AF (audio frequency) meter is a seven-segment LED containing
five green, one yellow, and one red segments. It displays the
audio signal strength received from the transmitter. Fewer lit
segments indicate a weaker audio signal compared to more lit
segments indicating a stronger audio signal. Red warns of a
potential clip.
RF (radio frequency) meter is a seven-segment LED indicator. It
displays the RF signal strength received from the transmitter.
Fewer lit segments indicate a weaker radio signal compared to
more lit segments indicating a stronger radio signal.
BNC RF jack to attach either a supplied half-wave whip antenna,
or antenna extension coax cable connected to a front-mounted or
Installation manual
RE3 UHF Wireless
Electro-Voice
Advertisement
Table of Contents
