Table of Contents
Advertisement
RE3 UHF Wireless
2
Press SET to start, or SYNC to quit.
3
Wait for scanning process to complete.
When scan is complete, view the results list.
Scroll through groups using ▲ or ▼ noting open channel
quantity per group.
4
Press SET on the group number having the number of open
channels which best meets your wireless system needs. This
advances to the CH number.
CH number is highlighted and displays the first open channel
in the group. While highlighted, scrolling through the open
channels using ▲ or ▼ will identify all open channels in the
5
group. Note that some channel numbers will not appear as
they are not open at the time of the scan.
Press SET on CH number. This selects that group and
channel the set will operate on.
6
This also returns to Result List on the scan menu.
Either scroll ▼down to Exit and press SET, or press SYNC on
the receiver front panel to return to the home screen. The
7
selected Group/Channel and associated Frequency displays
on the home screen.
NOTE: This group and channel must be set on the transmitter as well. Follow the SYNC
operation steps to sync the transmitter to the receiver, or manually set the transmitter to
this group and channel.
NOTE: This process is required for any system of sets, either a single set system, or a
multi-channel system.
ALL SETS in a multi-channel system operating on the same frequency band MUST use the
same group number.
7.3.4
Using the result list during the same session
A session is the period of time after a scan has been performed prior to a receiver power-
down. All scan data is stored in temporary memory until power-down. The session expires
upon receiver power-down.
Electro-Voice
Installation manual
RE3-RX receiver | en
27
OR
2021.06 | 03 | F.01U.362.808
Advertisement
Table of Contents
