Installing Batteries; Re3-Bpt Setup Menu - Electro-Voice RE3-BP0L-T Instruction Manual

en | RE3-BPT bodypack transmitter
50
d Frequency in kHz
e Keylock icon
f MHz
g AutoOff icon
h Mute icon
9.3

Installing batteries

Gently press the sliding magnetic battery door latch (item 6 shown above)

downward to unlock, while at the same time rotating the hinged battery door (item 8
shown above) downward to fully open the battery compartment.
Install two fresh, high quality AA alkaline batteries (or fully charged AA size NiMH

rechargeable cells) paying close attention to match the polarity markings (+ and -)
on each battery to the polarity markings (+ and -) on the battery contacts.
Rotate the hinged battery door upward until the compartment door latches shut.

The magnetic latch will lock the compartment door.
9.4

RE3-BPT Setup Menu

Editing any of the following parameters locally on the transmitter is possible. These edits
will override the settings synced from the mated receiver. Additionally, any parameter value
changes made locally on the transmitter may be overwritten the next time the transmitter is
synced to the mated receiver if those parameters are selected in the receiver's sync
configuration.
NOTE: No local edits will be possible if the transmitter is in Keylock mode (lock icon
displayed). See unlocking instructions below.
NOTE: Press and hold SET for three seconds to enter parameter edit mode. The frequency
in millions will begin flashing. Once in parameter edit mode, pressing SET multiple times
will advance through the adjustable parameters one parameter per press. The press and
hold of SET to enter parameter edit mode counts as the first SET button press.
2021.06 | 3 | F.01U.362.808
screen is set to display Group/Channel, this screen area will
display current group number.
The second portion of the tuned frequency to the right of the
decimal in thousands when the transmitter home screen is set to
Freq. If screen is set to display Group/Channel, this screen area
will display current channel number.
Indicates transmitter is in lock mode.
Image is visible the transmitter home screen is set to Freq. Image
does not appear when the transmitter home screen is set to
Group/Channel.
This icon indicates auto off is engaged. It begins flashing when
the transmitter is muted indicating the countdown to shutoff has
begun.
The display shows MUTE only when the transmitter is muted.
Installation manual
RE3 UHF Wireless
Electro-Voice